OKI Hatch Prototype — Cross-Up Layout DIY Case

This OKI Hatch prototype is ready for its next build. It features a Cross-Up layout, red and black accents, and matching “OKI Hatch Service Deck” artwork beneath the clear top panel.

A compact case for someone looking to build their own setup with a lever and additional directional buttons.

• Dimensions: 16" W × 9" D × 1.5" H
• Cross-Up layout with lever mounting area
• Hinged top panel for interior access
• Side carry handle
• Red, black, and gray corner accents
• Matching “Run the Set” bottom artwork
• Two textured bottom grip pads

Prototype condition: Please review all photos for the case’s finish, construction, and condition.

DIY enclosure: Shown without a lever, buttons, PCB, or wiring installed. These components are needed to complete the controller.